The Devimat 100 is a self adhesive mesh with an ultra-thin heating cable pre-attached which is just 3.5mm thick. The mat we offer is the 100 watt variant.
The cable is spread evenly on a backing mesh for easy laying and to prevent any cold spots.
The width of the mat is 500mm and it is available in various different lengths.
We offer 14 different size options ranging from 1.0m2 to 12.0m2.
Step by Step Instructions
Step 1 Measure the room and draw a sketch to help you calculate which DEVI package you will need. Then sketch in the position of the devimat heating cable mat.
Step 2 Mark the positioning of the toilet before you remove it. This helps you avoid placing the toilet on top of the mat - and prevents you from piercing it with screws.
Step 3 Cut a channel approx. 10 mm deep and wide in the wall and the floor, from the thermostat and about 1 m out into the floor. Glue the flex pipe for the sensor into this channel, and seal the end of the pipe with a piece of tape.
Step 4 Clean the floor thoroughly, removing all dirt and soap residue, then lay out the self-adhesive cable mat. The floor surface must be primed if you are not laying the mat on existing tiles.
Step 5 Clip through the grey netting to turn the mat over - but make sure that you do not cut through the red cable!
Step 6 Turn the mat and position it as required. The self-adhesive effect can withstand 10-20 adjustments, so you can move the mat several times until you are satisfied with the result.
Step 7 Once you have positioned the cable mat, you can - depending on the new floor surface - encapsulate it using selflevelling screed or cover it with a thin layer of tile adhesive.
